Maintenance

Recommendation for maintenance intervals under ideal operating conditions and continuous operation:
First maintenance after 100 operating hours, then every 3000 operating hours/ 4 months.

Cleaning and maintenance may only be undertaken by qualified personnel and under observation of the enclosed safety instructions.

Cleaning and maintenance intervals should be determined by the operating company. Frequency and measures depend on the operating conditions.

Risk of skin burns in the vicinity of the fan caused by hot air medium, hot motor or hot housing. There is a danger to life near high-temperature fans with airstream temperatures of up to 200 °C.

Before working on the fan, wait until it (motor, housing) has cooled sufficiently and the air medium has mixed with cold air and cooled to below 60 °C. The fan should then only be approached close up and then only be touched if you are certain that it has cooled down. This applies in particular to high-temperature fans.

Danger during maintenance work with protective equipment removed

Work with due regard for safety and an awareness of hazards if you have to undertake maintenance work with protective equipment removed, e.g. when taking measurements on live parts.

Regular maintenance

  1. Use the inspection switch to switch the fan Off/Aus and fit a padlock to make sure it isn't switched on again.
  2. Wait until the fan has cooled down sufficiently and the impeller is stationary before removing the weather protection hood or any other protection against accidental contact or touching the fan.
  3. Remove the weather protection hood.
  4. Block the impeller so that it cannot move any more. This protects you from unforeseen rotary movements, such as those which may be caused by air flows in the ventilation channel.
  1. When air is drawn in, frictional/grinding dusts or corrosive air may wear the impeller and cause vibrations. Clean the impeller as previously described. If the impeller is heavily worn, replace it with a genuine spare part.

The manufacturer does not accept any liability for damage which can be traced back to dirt deposits on the impeller.

  1. Check the minimum spacing between the impeller and impeller housing, the impeller shaft and exhaust opening. Ensure that the impeller is not rubbing and that the impeller housing has not distorted. Changes to spacing or loose screws may make re-alignment necessary.
  2. Regularly check the motor for abnormal vibrations and noises.
  3. Check the condition of welds and resistance to oxidation.
    Replace oxidised screws and nuts.
  4. Check the condition of the seals. Replace damaged seals.
  5. Regularly check that the protective devices are fully functional. Should they malfunction or be heavily worn, replace them to ensure smooth operation.
  6. To prevent the motor from overheating, ensure that the air inlet is not blocked.
  7. Refit any components you may previously have removed (e.g. protective grille).
  8. Fit the weather protection hood and tighten the two ring nuts.
  9. Regularly check the motor for abnormal vibrations and noises.
  10. Check that guards are fully functional. Ensure that they are working properly.

Overheating and damage to units resulting from stopping at temperatures >60 °C

In no circumstances should you stop the fan before the air medium inside it has reached a temperature of <60 °C. This will protect the motor from damage caused by overheating. If this temperature cannot be guaranteed, external cooling systems must be used. If the temperature inside the fan increases while it is idle, the operator must wait for the temperature to fall to below 60 °C before restarting.