Teaching-in transmitters

When a teach-in telegram is correctly received, the receiver’s button’s LED lights up for 1 second. The transmitter is now set up.

Teaching-in radio switches

In the case of double-rocker switches (DS RC), both rockers have to be taught-in separately (2 channels).

  1. Activate teach-in mode on the receiver fan.
  2. LED flashes. Teach-in mode is activated.
  3. Press the radio switch’s right-hand rocker switch 3 times within 2 seconds.
  4. The teach-in telegram is sent. If teaching-in was successful, the LED lights up for approx. 1 second. If transfer was faulty, the button LED flashes briefly 3 times.
  5. Reactivate teach-in mode on the receiver fan.
  6. Press the radio switch’s left-hand rocker switch 3 times within 2 seconds.
  7. The teach-in telegram is sent. If teaching-in was successful, the LED lights up for approx. 1 second. If transfer was faulty, the button LED flashes briefly 3 times.
  8. Reactivate teach-in mode on the receiver fan.
  9. Press the right-hand rocker switch 3 times within 2 seconds.
  10. The teach-in telegram is sent.

Teaching-in radio window contacts

  1. Activate teach-in mode on the receiver fan.
  2. The LED flashes, teach-in mode is activated.
  3. Press the teach-in button on the radio window contact.
  4. The teach-in telegram is sent. If teaching-in was successful, the LED lights up for approx. 1 second. If transfer was faulty, the button LED flashes briefly 3 times.

Teaching-in an RLS RC room air control

The teach-in button is on the rear side of the RLS RC.

  1. Activate teach-in mode on the receiver fan.
  2. The LED flashes on the fan, the teach-in mode is activated.
  3. Press the RLS RC teach-in button 3 times within 2 seconds.
  4. The teach-in telegram is sent. If teaching-in is completed successfully, the radio icon in the display flashes briefly 3 times. The radio icon is then permanently visible in the display.
  5. The LED on the receiver fan lights up for 1 second upon successful teach-in.

Teaching-in slave fan

  1. Activate teach-in mode on the master (receiver fan) and a fan that is not yet taught-in (planned slave).
  2. The LED flashes, teach-in mode is activated.
  3. Switch the slave fan to the send mode To do this, press the teach-in button on the slave fan once.
  4. The LED on the slave lights up for a short time and then flashes briefly once. The slave fan is now in Send-learn mode.
  5. Press the teach-in button on the slave fan (>1 second) until the LED on the slave fan lights up briefly once.
  6. The teach-in telegram is sent. If teaching-in is completed successfully, the button LED lights up once for approx. 1.5 seconds. If transfer was faulty, the button LED flashes briefly 3 times. If the teach-in process fails the LED on the slave fan flashes briefly 3 times. The process has to be repeated.