Fault messages of RLS 45 K
| Internal error in RLS Fault rectification: Ensure that no voltage is present, restart the control. To perform a reset of the control, press
|
| Overtemperature/overload of mains adapter Fault rectification: Check the ambient temperature and allow the mains adapter to cool down. |
| No communication and/or failure of the external power units/RLS or PPB 30 K Fault rectification: Check connection to the LT/RLS. Check the settings in the software (e.g. activated LTs that are not connected). Incorrect addressing (e.g. two slaves with the same address). |
| No communication and/or failure of the sensors (RS 485, I2C) Fault rectification: Check connection to the sensors. Check settings in the software (activated sensors that are not connected). |
| Internal system error – RLS/PPB 30 K slave power unit Fault rectification: Switch off the voltage. |
| No communication with the EnOcean module (PP 45 EO) Fault rectification: Check wiring. If the connection is correct, the error disappears. |
| No communication with taught-in sensor / error message from PP 45 RC Fault rectification: Check cable connection to taught-in sensor. To PP45 RC: Check the device status in the commissioning software (EnOcean wireless query). |
| LED flashes |
| LED lit up continuously |
+
5 seconds long.
