Radio components which can be taught-in (EEP)
PP 45 / PPB 30 radio components must support the EEP protocol. The radio components can be combined with the EEP specified below.
Type | EEP |
|---|---|
DS 45 RC radio switch, 4-channel wall transmitter | F6-02-01 |
Humidity/temperature sensor* | A5-04-01 |
CO2/temperature sensor | A5-09-08 |
VOC/temperature sensor** | A5-09-05 |
PP 45 ACT: 1-channel recessed-mounted switch | D2-01-01 |
* Not available for PPB 30 units.
** No EnOcean VOC sensor currently available.
If within range, up to 8 radio sensors can be used with radio-controlled systems.
Radio actuator PP 45 ACT (1 channel): The PP 45 Act can be used to activate the “Supply air for exhaust air units” function for PP 45 RC units. The PP 45 ACT is connected and taught-in in accordance with the enclosed installation and operating instructions.
Teaching-in tips
- Radio components are taught-in directly on the RC-Master (TEACH key).
- Only one slave unit can be assigned to each master ventilation unit of the same type. Exception: In systems with PP 45 RC and PPB 30 RC unit pairs, the additional teaching in of the PPB 30 RC into the master PP 45 is possible.
- Correct operation of a unit pair is monitored by the master unit.
- Teach-in mode is deactivated each time a radio component is saved, meaning that it has to be called up again for each further component.
- If nothing is received within 120 seconds, the teaching-in process is ended (the LED on the ventilation unit switches off).
- Teach-in telegrams from non-supported units are ignored.