Electrical connection

The remote control supplied with the RLT unit is connected to the RJ12 terminal on the Corrigo controller using the connection cable also supplied.

Connection to the Corrigo controller:

Terminal assignment:

Colour assignment:

1: Schwarz / Black

2: Weiss / White

3: Gelb / Yellow

4: Braun / Brown

If a separate cable is used instead, this may be a maximum of 100 metres long. The control panel can be mounted on the wall, on a flush-mounted box (drilling distance 60 mm) or on a control cabinet using the magnetic strips supplied. The magnetic strips are stuck to the back of the device. With this mounting variant, the cable should be routed through the alternative outlet under the connection compartment. See the following figure.

It is also advisable to attach a cable tie (see figure below) to prevent the cable from being pulled out.