Connection cable
Note the circuit diagrams provided with the unit.
Danger of short circuits/damage to unit should water enter the electronics compartment.
Ensure correct connection.
The cable feedthrough for the external connecting cables can be found on the rear side of the unit, on the top left side of the right-hand unit and on the top right side of the left-hand unit.
The following six cables are led out of the unit as standard:
- Mains connecting cable (3x1.5 mm²), length: approx. 3 m.
- Control cable for RLS T1 SYS or RLS G1 WS control panel or for Modbus RTU (4x 0.34 mm²), length: approx. 3 m.
The control cable must be clamped on the main board in the geniovent.x unit to suit the desired function!
- Connection cable for RLS 1 WR (6x 0.5 mm²), length: approx. 3 m.
- Connection cable (Ölflex) for external components/functions (12x 0.75 mm²); length: approx. 3 m. Note: SW1+SW2 cable cores bridged upon delivery (see wiring diagram. If not bridged, it may not be possible for the unit to be started).
- Ethernet cable with RJ45 socket for connecting to network; length: approx. 1 m.
- USB cable with type B USB connector for commissioning software run via laptop/PC. Length: approx. 0.5 m.