ER-UP/G ceiling installation, single room

6

Protective grille

7

Filter mat, filter class G2

8

Adapter

9

Suction duct, second room connection: flexible aluminium duct AFR 75/AFR 80

10

Installation socket for second room extraction DN 75/80

13

Housing floor seal

37

Mounting support UPM 60/100 (2 items)

S

Housing segment

  1. Remove the plaster protective cover from the housing.

  2. The unit will be damaged and function impaired if the fixing screws used are incorrect/too long.

    Fixing screws may not penetrate into the housing.

    1. Use the screws provided (UPM 60/100 mounting support).
  3. For suspended ceilings, cut mounting support to the required length, bend it into shape and fix it to the housing (ER GH wall installation, single room).
  4. Mark fixing holes for mounting support/housing on ceiling, produce holes and insert dowels. Suitable mounting material is to be provided by the customer.

  5. Danger of short-circuits and damage to the unit.

    If the cable grommet is not installed correctly, water may penetrate the housing. The degree of protection can no longer be guaranteed.

    1. Drive through cable grommet so that it can seal the cable sheathing all the way round (circular, no slots).
  6. Guide power cable from rear of housing through cable grommet into housing.
  7. Move housing into desired position and secure to ceiling with/without mounting support.

Fire may spread if connection duct is incorrectly installed.

  1. Only use permitted duct material (Requirements in line with approval).
  2. Correctly attach connection duct to exhaust socket.
  1. Connect connection duct to exhaust socket sealed for ventilation, e.g. with cold-shrink tape.
  2. Provide unit with electrical connection: Electrically connecting the unit.
  3. Insert the plaster protective cover in the housing.
  1. Plaster in housing flush with front edge.